The stock exhaust of the Porsche 997.2 turbo is very restrictive compared to aftermarket systems. Porsche does this to meet sound and emission purposes like most OEM manufacturers. agency power set out to create an exhaust system for the new Porsche 997.2 turbo 6speed or pdk that did not drone, would produced amazing performance, and under throttle give an incredible sound. we have accomplished this! the new agency power exhaust not only saves about 30lbs off the rear end, it also improves power quite a bit.
With our single can muffler and 200cell high flow cats installed to the stock huge oval tips, we strapped our 2010 pdk to the dyno. The exhaust made a peak increase in standard mode of 15awhp and 23f...(choose a part on the right to read more)
This is a factory series borg warner / kkk k27 turbocharger. It is a direct replacement for part # 930 123 003 01 which is currently no longer available from the factory. We source this from an OEM supplier with exacting standards in Germany. Features: restore factory performance direct replacement includes turbocharger hose 93011036801eq includes hose clamps sold individually. 1 necessary per car. Please note: there is no applicable core charge on this turbo. We send you a newly remanufactured unit with hose and clamps.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
High-quality OEM replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. Sold individually.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
Each hose sold seperately. These long-lasting aircraft quality heater hoses conduct only the hottest heat to the front of your Porsche, while providing flex during engine movement! Order 4 hose clamps as well! Fit under the car near the engine and connect between the heater control valve and the body. 60 x 330 mm
-new compressor with clutch, compatible with r134a and r12
-ester refrigerant oil, compatible with r134a or r12
-r134a charge port adapters.
-kuehl kwick mounting bracket & hardware
-new compressor to rear deck lid condenser barrier hose line assembly with sae approved crimped fittings and our high-low pressure switch feature. The condenser side fitting of the hose assembly will be flare.
-new compressor to evaporator barrier short hose; with sae crimped fitting on the compressor side. This allows you to cut & splice to old suction line in the engine compartment using a barb fitting with clamps supplied in the kit.
-new receiver drier, Porsche configuration.
-detailed installation instruc...(choose a part on the right to read more)